Manual 2100-757
Page
6 of 17
INSTALLATION
Basic Installation
1. Unpack the ventilator assembly which includes the
integral ventilator with attached electrical harness
and miscellaneous hardware.
MIS-2416
FRONT DOOR
VENT OPTION
PANEL
VENT TERMINAL
RIGHT FRONT
CORNER
EXHAUST COVER
PLATE
2. Open the front door. Remove and save vent option
panel from wall mount unit (see Figure 3).
3. Remove and save existing unit air filter and screw
from front center grille (see Figure 5 on page 8 for
screw location).
4. Remove and discard the exhaust cover plate.
5. Replace the exhaust cover plate with screen that is
included with the kit.
6. Install loose piece wire harness shipped with kit
(as shown in Figure 4).
FIGURE 3
Removal of Vent Option Panel
WARNING
Open and lock unit disconnect switch before
installing this accessory to prevent injury or
death due to electrical shock or contact with
moving parts. Turn thermostat to off.
MIS-2416
Summary of Contents for WGSCRVS-3C
