Startup
1. Verify that the AC Voltage select switch on the rear panel is in the correct position for the AC
voltage in your facility (see warnings on previous page for details) then plug in grounded mains
power cable.
2. Set Input toggle switch to either analog (A) or digital (D) depending on the type of source signal
you are using. For digital signals also set the Channel toggle switch to left (L) or right (R) in
accordance with the speaker position.
3. Ensure that the audio signal is fully attenuated (AES3 signal requires digital attenuation).
4. Power on the speaker with the rocker switch located on the rear panel above the mains connector.
The LED indicator on the front of the speaker will illuminate Red for a couple of seconds then turn
Aqua.
Connections
Analog:
Digital:
Analog Source
AES3 Source
* See Section 11 for Voice connection details.
AES/EBU
Splitter
Summary of Contents for MicroMain26
Page 1: ...Owner s Manual...
Page 19: ...Dimensions inches mm...