40
10.2 PUTTING THE PRODUCT OUT
OF OPERATION – DISPOSAL
Please make the product inoperative before dis-
posal. Older units also include reusable materials.
Take them to the waste separation site.
The product should be dismantled in a specialized
centre so that the recyclable materials can be re-
used.
Parts that cannot be recycled in should be taken
to a legal waste disposal site.
Materials must be disposed of in accordance with
applicable national regulations and directives.
10.3 DISSASEMBLY AND DISPOS
AL
Disassembly of motors
Release the hold from setup – square bit No. 2
Release the motor from the hold – allen bit No. 2.5
Printed circuit boards
Opening the board – flat screwdriver
Disassembling the board out of the plastic
clusters
– pliers for precision mechanics
Release of the PCB – Philips screw No. 0
Plastic parts
Allover isolation of the front panels – breaking
knife
11. IN CONCLUSION
Please read this manual carefully and follow its
in-structions to ensure correct and safe operation
of the heat recovery unit.
Should you have any questions or require some
additional explanation, please do not hesitate to
contact our sales department or technical
support.
Contact:
Barkell Ltd
Unit 22
No. 1 Industrial Estate
Consett
Co. Durham
DH8 6SZ
Internet:
http://www.barkell.co.uk/
Copyright ©
All rights reserved.
The
manufacturer
is not responsible for damages incurred on the device, which were caused by an inexpert installation
and service, which are contrary with the manual and conventions during installation and the service of ventilation units
and regulation systems
Version 1.
1
,
13/07/2018
