LIGHTING & POWER SUPPLIES
REPLACING LED LIGHTS
Once store power is connected and the light circuit is ener-
gized, the Clearvoyant LED system should operate without
the need for any signifi cant maintenance for several years.
Should a power supply need to be removed and/or replaced,
turn off the power to the case before proceeding. Be certain
to replace the power supply with genuine Hillphoenix parts or
a comparable UL-listed Class-2 rated regulated 24V DC power
supply with 100W output capacity.
SHELF LUMINAIRES
Removing shelf luminaires:
1.
Unplug the luminaire.
2.
Pinching the latching clips inward at the ends of the lumi-
naire, rotate luminaire up at each end until hooks are free,
then remove.
Re-installing shelf luminaires:
1.
Place hook into shelf roll form at shelf front and rotate
rear of luminaire toward the shelf.
2.
Depress the rear clip so that luminaire can fi nish rotation
and until clip engages the shelf bracket.
NON-SHELF LUMINAIRES
Removing non-shelf luminaires:
1.
Simultaniously squeeze the plastic clips at each end.
2.
When the hooks are disengaged, pull the luminaire free.
Re-installing non-shelf luminaires:
1.
Align the 4-pole jack with the 4-pole connector on the clip-
in luminaire.
2.
Push into place - side clips will engage on the sheet metal
of the case.
3.
Fasten anti-tamper bracket into sheet metal of case with
#8 screw at end opposite of the 4-pole in-line connector
D A N G E R
▲
SHOCK HAZARD
Always disconnect power to case when cleaning,
servicing or confi guring components of the light-
ing system. Failure to do so may result in serious
injury or death.
Fig. 10 Clear view of the ballasts
BALLAST
14
Summary of Contents for GMD-R
Page 2: ...ii...
