page 59
page 59
page 59
page 59
page 59
160B&C TM
800-00140
TA-19 SWING PUMP MAINTENANCE CONTINUED...
TA-19 SWING PUMP MAINTENANCE CONTINUED...
TA-19 SWING PUMP MAINTENANCE CONTINUED...
TA-19 SWING PUMP MAINTENANCE CONTINUED...
TA-19 SWING PUMP MAINTENANCE CONTINUED...
completely purged of such air in the time it remains in the reservoir before recycling through the system.
3. Aerated fluid can be caused by ingestion of air through the pipe joints of inlet lines, high velocity discharge lines,
cylinder rod packings or by fluid discharging above the fluid level in the reservoir. Air in the fluid causes a noise
similar to cavitation.
F. OVERLOAD PROTECTION
F. OVERLOAD PROTECTION
F. OVERLOAD PROTECTION
F. OVERLOAD PROTECTION
F. OVERLOAD PROTECTION
Relief valves limit pressure in the system to a prescribed maximum and protect components from excessive pressure.
The setting of a relief valve depends on the work requirements of the system components and are for intermittent use
only.
Relief valves are not required for all applications. In applications designed without relief valves, pressure relief is obtained
by spinning the wheels.
SECTION V - SERVICE AND MAINTENANCE
SECTION V - SERVICE AND MAINTENANCE
SECTION V - SERVICE AND MAINTENANCE
SECTION V - SERVICE AND MAINTENANCE
SECTION V - SERVICE AND MAINTENANCE
A. SERVICE TOOLS
A. SERVICE TOOLS
A. SERVICE TOOLS
A. SERVICE TOOLS
A. SERVICE TOOLS
The following standard tools for overhauling the transmission pump are:
1. Torque wrench with short extension and sockets.
2. (0-1 inch) micrometer.
3. (0-1 inch) depth micrometer.
4. Internal Truarc pliers.
5. External Truarc pliers.
In addition to the service tools, an arbor press is required to service bearings, etc. Maintenance of this unit is intricate
and should not be attempted without the proper tools.
SPECIAL TOOLS
Special tools are shown in Figures 4, 5, 6, and 7.
Special Shaft Bearing Removal and
Special Shaft Bearing Removal and
Special Shaft Bearing Removal and
Special Shaft Bearing Removal and
Special Shaft Bearing Removal and
Installation Tools
Installation Tools
Installation Tools
Installation Tools
Installation Tools
Figure 4
Figure 4
Figure 4
Figure 4
Figure 4
Figure 5
Figure 5
Figure 5
Figure 5
Figure 5
Bearing Race Removal Tools
Bearing Race Removal Tools
Bearing Race Removal Tools
Bearing Race Removal Tools
Bearing Race Removal Tools