page 14
page 14
page 14
page 14
page 14
275B SER
800-00152
FIRE PREVENTION
FIRE PREVENTION
FIRE PREVENTION
FIRE PREVENTION
FIRE PREVENTION
The electrical system, if damaged or incorrectly maintained, can be a source of arcs or sparks.
Avoid conditions where explosive dust or gases can be ignited by arcs, sparks or heat.
Flammable debris (twigs, leaves, straw, etc.) must be removed on a daily basis or more often if necessary.
Excessive debris will increase the condition for a fire hazard. Clean the machine often.
FIRE PREVENTION CHECK LIST
FIRE PREVENTION CHECK LIST
FIRE PREVENTION CHECK LIST
FIRE PREVENTION CHECK LIST
FIRE PREVENTION CHECK LIST
The following list provides data which will help to prevent fires.
-
Do not use the machine in areas with explosive dust or gases. These elements can be ignited by arcs,
sparks, or hot components.
-
Inspect the cab, motor compartment, and cooling system every day. Clean if necessary to prevent
overheating. Remove all flammable material (rags, debris, fluid spills, etc.).
-
Inspect all electrical wiring and connections for damage daily. Replace or repair any damaged part.
-
Daily, inspect all hydraulic oil tubes, hoses, and fittings for damage and leakage. Tighten or replace as
necessary. Always clean fluid spills.
-
Clean the machine and disconnect power before doing any welding. Cover rubber hoses and other
flammable parts. Never ground arc welder or electrical accessories through turntable or boom bearings
as arcing may occur, causing bearing damage.
WARNING
WARNING
WARNING
WARNING
WARNING
Do not weld on any structural member unless
Do not weld on any structural member unless
Do not weld on any structural member unless
Do not weld on any structural member unless
Do not weld on any structural member unless
specifically authorized by Barko Hydraulics.
specifically authorized by Barko Hydraulics.
specifically authorized by Barko Hydraulics.
specifically authorized by Barko Hydraulics.
specifically authorized by Barko Hydraulics.
Any unauthorized welding or welding procedures
Any unauthorized welding or welding procedures
Any unauthorized welding or welding procedures
Any unauthorized welding or welding procedures
Any unauthorized welding or welding procedures
will void the warranty, and may cause structural
will void the warranty, and may cause structural
will void the warranty, and may cause structural
will void the warranty, and may cause structural
will void the warranty, and may cause structural
damage.
damage.
damage.
damage.
damage.
-
Read the Electric Motor Manual accompanying this manual for complete motor operating and motor
safety instructions.
-
Keep a fire extinguisher nearby.
