page 57
page 57
page 57
page 57
page 57
275B SER
800-00152
MFE19 SWING MOTOR MAINTENANCE CONTINUED...
MFE19 SWING MOTOR MAINTENANCE CONTINUED...
MFE19 SWING MOTOR MAINTENANCE CONTINUED...
MFE19 SWING MOTOR MAINTENANCE CONTINUED...
MFE19 SWING MOTOR MAINTENANCE CONTINUED...
INSTALLATION AND OPERATION INSTRUCTIONS
INSTALLATION AND OPERATION INSTRUCTIONS
INSTALLATION AND OPERATION INSTRUCTIONS
INSTALLATION AND OPERATION INSTRUCTIONS
INSTALLATION AND OPERATION INSTRUCTIONS
A.
A.
A.
A.
A. MOUNTING AND DRIVE CONNECTIONS
MOUNTING AND DRIVE CONNECTIONS
MOUNTING AND DRIVE CONNECTIONS
MOUNTING AND DRIVE CONNECTIONS
MOUNTING AND DRIVE CONNECTIONS
CAUTION
CAUTION
CAUTION
CAUTION
CAUTION
Motor shafts are designed to be installed in couplings with
Motor shafts are designed to be installed in couplings with
Motor shafts are designed to be installed in couplings with
Motor shafts are designed to be installed in couplings with
Motor shafts are designed to be installed in couplings with
a slip fit. Pounding can injure the bearings.
a slip fit. Pounding can injure the bearings.
a slip fit. Pounding can injure the bearings.
a slip fit. Pounding can injure the bearings.
a slip fit. Pounding can injure the bearings.
1. Direct Mounting:
-
A pilot on the inline piston motor mounting flange (Figure3) assures correct mounting and shaft alignment.
Figure 3
Figure 3
Figure 3
Figure 3
Figure 3
-
Make sure the pilot is firmly seated in the accessory pad.
-
Care should be exercised in tightening the mounting screw to prevent misalignment.
2. Indirect Mounting:
-
Indirect drive is not recommended for these motors.
B.
B.
B.
B.
B. SHAFT ROTATION
SHAFT ROTATION
SHAFT ROTATION
SHAFT ROTATION
SHAFT ROTATION
Motors are capable of rotation in either direction. To reverse motor direction, simply reverse flow direction.
C.
C.
C.
C.
C. PIPING AND TUBING
PIPING AND TUBING
PIPING AND TUBING
PIPING AND TUBING
PIPING AND TUBING
1. All pipes and tubing must be thoroughly cleaned before installation. Recommended methods of cleaning are sand
blasting, wire brushing, and pickling.
2. To minimize flow resistance and the possibility of leakage, only as many fittings and connections as are needed for
proper installation should be used. Connecting lines (hose or tubing) should be at least the SAE port size of unit.
3. Keep number of bends in tubing to a minimum to prevent excessive turbulence and friction of oil flow. Tubing must
not be bent too sharply. The recommended radius for bends is three times the inside diameter of the tube.
D. OVERLOAD PROTECTION
D. OVERLOAD PROTECTION
D. OVERLOAD PROTECTION
D. OVERLOAD PROTECTION
D. OVERLOAD PROTECTION
Relief valves limit pressure in the system to a prescribed maximum and protect components from excessive pressure.
The setting of a relief valve depends on the work requirements of the system components.
Motor Pilot Flange
Motor Pilot Flange
Motor Pilot Flange
Motor Pilot Flange
Motor Pilot Flange