13-24
®
OPERATING & LOADING TECHNIQUES
1 OPERATING SAFELY
Ÿ
Safety is the operator's responsibility.
It is the
operator's responsibility to read the manual
thoroughly, understand the machine's control
functions and all safety precautions and
warnings before operating the machine.
Even if you are an experienced operator, don't
assume that controls on this machine are the
same as other similar equipment. Understand
and acknowledge the differences of this
machine before operating.
Ÿ
Walk around the machine and warn all
personnel who may be near the machine or
in the machine path before starting.
Do not
start until all personnel are clearly away from the
machine.
Ÿ
Establish a safe work area:
Ÿ
where there is plenty of maneuvering room
Ÿ
where ground is smooth, even and firm
Ÿ
where there are no obstacles
Ÿ
Know the perimeters of the established work
area.
Ÿ
Do not set up the work area:
Ÿ
near edges of a ditch
Ÿ
in slide areas
Ÿ
near river or stream banks
Ÿ
near overhangs or excavation sites
Ÿ
Always wear the seat belt, if provided.
Ÿ
Always remain in the operator's seat while
machine is energized and/or while boom is
lifted.
Ÿ
Start and operate the machine only from the
operator's station.
Ÿ
If equipped, do not operate machine without
lowering stabilizers.
Ÿ
Move controls slowly to get the feel of the
machine.
Ÿ
Unlike mechanical joysticks, hydraulically
operated (servo) controls become inert when
engine is shut down and hydraulic power is
lost.
2 OPERATING PROCEDURES
This machine is built to lift loads and is
extremely powerful.
Do not operate carelessly.
There is potential for personal injury and equipment
damage. Be concerned about safety when
preparing to operate machine. Operator must
handle load so that maximum stability is
maintained. Be familiar with size and weight of
handled materials.
Ensure safe operation by inspecting machine
as stated in Pre-Start Checklist in the MACHINE
PRE-START UP section
. This inspection amounts
to a common sense visual check of machine at
beginning of every operation. Follow a preventive
maintenance program; such a procedure will
reduce possibility of costly down time.
Read the MACHINE START UP section of this
manual.
Know all the steps in the
Starting
Procedures
...
Ÿ
know how to
idle the engine
to allow the
hydraulic system to warm up
Ÿ
know when and how to
raise the engine
RPM
Ÿ
know when to activate
Control Power
Switch
and the
Servo Controls
Ÿ
learn the
Cold Weather Starting Procedure
Ÿ
know how to safely
Jump Start
your BARKO
machine
Read the MACHINE SHUT-DOWN section of this
manual.
Know all the steps in
Stopping & Parking
the Machine
...
Ÿ
know to apply the braking system an lower
the boom
Ÿ
know when and how to
decrease the
engine RPM
Ÿ
know when to de-activate
Control Power
Switch
and the
Servo Controls
Take advantage of easy operation of your
BARKO machine.
Ÿ
keep operating distance as short as possible
Ÿ
keep work area small to shorten cycle time
Ÿ
plan ahead to place machine, stock pile, and
loading area in position for as short a cycle
as possible to increase production
07/26/2018
Updated
OPERATOR’S
Summary of Contents for 295B
