BARMATIC COOLICE ICE250, User Manual

10

EN

Installation

•  Remove and disassemble all packaging materi-

als of the product before installation. 

•   The ice slide grate, waterproofing plastics and 

the ice scoop are provided inside the product. If 
any part or accessory is missing, please contact 
our customer services.

•   Clean the inner cabinet with warm water and a 

soft cloth before using the ice maker. Clean the 
ice trays with warm soapy water. Dry with a soft, 
cotton cloth. After placing the ice maker at the 
installation point, wait 2 (two) hours before op-
erating to get the cooling system pressure sta-
bilized. Install the parts inside the ice maker in 
accordance with the assembly instructions.

•   The cold water inlet pressure must not exceed 

the operating water pressure (5 Bar) indicated 
on the technical data sheet. If the line pressure 
is higher than 5 Bar, a pressure reducer must be 
installed.

•   

Connect your device to the mono phase - 
grounded power supply of the rating indicated on 
the nameplate. Your device is designed to func-
tion normally within ± 10% of the main voltage. If 

this range cannot be provided in your local pow-
er network, it is recommended to use a voltage 
regulator.

•   If it is necessary to change the location of your 

ice maker, be sure to transport the unit accord-
ing to the markings on the original packaging of 
the device.

•   Protect your device against factors that may 

damage the package and the device (moisture, 
water, impact, chemical, etc.).

•   Only Authorized Service should disassemble the 

device. Never interfere with the internal parts 
and elements of the ice-maker.

•   The device must be commissioned by the Au-

thorized Service.

•   Failure to comply with the above conditions will 

void your product warranty.

•   Do not leave packaging materials (plastic bags, 

nylon, etc.) within the reach of children.

•   The manufacturer reserves the right to change 

the information in this manual. Therefore; this 
booklet does not constitute a commitment to 
specifications.

Usage instruction

Operating

After installing your Ice Maker following the in-
structions above and making all necessary 
connections
•   Make sure that the power outlet you are using for 

your ice-maker is live and has power.

•   Turn on the water.
•   Set the On-Off button at the front of your prod-

uct to the On position. (When you set it to the On 
position, the power light on the button will turn 
on.). 

•   The product will automatically go into a de-

lay-time mode for 1 minute after it is turned on.

•   At the end of the delay-time mode, the product 

will start getting water and making ice.

•   Your product will complete the ice-making cycle 

after a certain time, depending on the ambient 
and water temperature.

•   To change the dimple size of the ice made by the 

ice maker, adjust the potentiometer in the direc-
tion of the arrow. (See Figure-2).

NOTE:

 In order to allow your product to make ice 

in the optimum dimple size and time, you need to 
wait for at least 2 hours after the installation, be-
fore turning on the machine. 

Shutting Off

•  Set the power button at the front of your Ice Mak-

er to “Off” position.

•   Unplug the product if you are not going to use 

the ice-maker for a long time.

•   Turn off the water.