BARMATIC COOLICE ICE250, User Manual

12

EN

Cleaning of the Ice Storage Bin

•   To clean the ice bin, first turn the power switch to 

the “Off” position. Then disconnect the product 
from the main power supply.

•   Drain the ice completely from the ice bin.

•    Wipe the inside of the ice bin with cleaning solu-

tion / soapy cloth and then rinse / dry.

•   Take care not to allow any lime and/or cleaning 

solution residue to remain.

Cleaning of the Water Inlet Filter

•    Disconnect the Ice Maker from main power 

supply.

•    Disconnect the water connection of your ice 

maker.

•    Remove the water inlet filter. (The frequency of 

cartridge replacement varies depending on the 
usage period, but it is recommended to change 
every 6 months.).

•   Follow the filter manufacturer’s maintenance 

and cleaning instructions / recommendations to 

perform cleaning and maintenance of the water 
inlet filter.

NOTE:

 Then return the Ice Maker to operation by 

following the installation instructions.

IMPORTANT:

 The applications specified in the 

product cleaning instructions should be performed 
at least 4-5 times a year.

13. Troubleshooting

Fault

Probable Cause

Solution

Ice Maker does not work

Power button is Off.

Set the power button to the “On” position. 

The power connection is faulty.

Get the power connection checked by a 
qualified electrician. 

The Ice Maker is in protection mode.

Check the place selection instructions of the 
ice maker. Ice Maker does not receive 
adequate amount of air.

No power in the outlet.

Check the fuse connected to the outlet. 

The compressor stops 
shortly after it starts 
working

Ambient temperature is very high.

Check the place selection instructions of the 
ice maker. Ice Maker does not receive 
adequate amount of air. Clean the ventilation 
filter.

Grid voltage is low.

Get the power connection checked by a 
qualified electrician.

Ice Set is cooled but the 
water inside the water 
pool is insufficient

Water valve is faulty

Contact the nearest Authorized Service. 

Water supply pressure is low

Make sure that the water supply pressure is 
greater than 1 Bar. 

Water level drain plastic group seeps

Place the water level plastic group to its slot 
tightly. 

Ice cubes are not 
transparent

Water nozzle is blocked

Water nozzle sprayer should be checked. The 
blocked nozzles should be cleaned.

Water pool is dirty

Clean the Ice Maker by following the cleaning 
instructions.

Pressure of the water pump is low

Contact the nearest Authorized Service. 

The water is blurry / dirty / chlorinated

Use a water filter.