29
1. Set the SERIAL BAUD rate using the arrow keys.
2. Press the MENU key to advance to the POWER UP CONTROL screen.
Power Up Control
This set up option allows you to specify one of two conditions for the Tem-
perature Controller at turn on. Power Up Control has two options: Last State
and Stopped. Refer to Figure 50.
POWER UP CONTROL
LAST STATE
FIGURE 50. POWER UP CONTROL SCREEN
The two selections are designed primarily to function in the event of a power
failure. If a power outage occurs, Last State will start the process from where
it last ended when the power went out, Stopped will leave the process off.
When a run time has been entered or the unit is in the RAMP and SOAK
mode, it will always power-up in the STOPPED mode.
1. Use the arrow keys to select one of the options and press the MENU key
to advance to the ADVANCED SET UP COMPLETE screen.
2. Once at this screen, the unit will automatically default to a message screen
which says SAVING SETUP. Setup is complete, and the operation screen
will be displayed.
