37
Installing the Paper Roll
When the red PAPER OUT light illuminates, it is time to
replace the paper roll. Replace the paper roll (AY669X4)
as follows:
1. Turn the printer ON and open the chamber cover.
2.
Make sure the edge of the paper roll is straight.
3.
Insert the paper roll into the printer. (See Figure
C.)
4.
Insert the paper straight into the paper slot (see
Figure D). The paper will feed automatically.
5.
Tear off a strip of paper and close the cover.
(The red PAPER OUT light will be OFF if paper
roll installation is successful.)
C
OMPUTER
/P
RINTER
S
ETUP
Note
A colored stripe along the edge of the
paper indicates that you are approach-
ing the end of the tape. When the
stripe appears, approximately 23 inch-
es (58.4 cm) of paper remains,
enough for 1-2 days. Replace the tape
before it is completely exhausted to
ensure a complete record of your
analysis.
Figure C: Inserting the Paper Roll
Figure D: Inserting the Paper Into the Paper Slot
Summary of Contents for NANOpure DIamond D11951
Page 52: ...Wiring Diagram 52...
Page 55: ...55 TITLE RIGHT...
