used with tYPE include; tGt target setpoint), Rate (rate of
temperature increase) and dur (time to target setpoint or
time to dwell).
End.t:
End of program.
AL LiSt (Alarm List)
IdHi:
Deviation High Alarm.
Atun LiSt: (Autotune List)
tunE:
One-shot autotune enable.
drA:
Adaptive tune enable.
drA.t:
Adaptive tune trigger level in display units. Range =
1 to 9999.
Pid LiSt
G.SP (Gain Setpoint):
If gain scheduling has been
enabled this parameter sets the PV (process value) below
which Pid1 (proportional band/integral time/derivative time)
is active and above which Pid2 is active.
Pb:
Proportional band in display units. (SEt 1)
ti:
Integral time in seconds. (SEt 1)
td:
Derivative time in seconds. (SEt 2)
Pb2:
Proportional band. (SEt 2)
ti2:
Integral time in seconds. (SEt 2)
td2:
Derivative time in seconds. (SEt 2)
SP LiSt (Setpoint List)
SP 1:
Setpoint one value.
cmS LiSt (Comms List)
Addr:
Communications address.
ACCS LiSt (Access List)
codE:
Access password. Not needed for
normal operation. Call Customer Service if configuration is
required.
19
O
PERATION
