![background image](http://html1.mh-extra.com/html/baroness/fs900/fs900_service-manual_3907959105.webp)
Neutral Position of the Piston Pump
Adjusting the Neutral Position of the Piston Pump
If the machine moves forward or backward
while the traveling pedals are released, they
are not set to the neutral position.
Follow the steps below to make adjustments.
Stop the engine.
Remove the cotter pin and washer from the
pedal end, and then disconnect the end of
the push-pull cable.
3
2
1
hsn2jo-003
Adjusting the Neutral Position of the Piston Pump_001
1
Push-pull cable
2
Cotter pin
3
Washer
Place the jacks beneath the jack-up points,
and then lift the machine off the ground.
Use stable jack stands, and raise the
machine until the tires lift off the ground.
(See "Jack-up Points" (Page 3-11) .)
Start the engine, and rev it up to the
maximum rpm.
Slowly rotate the camshaft until the rear
wheels stop, and then lock the camshaft
with the nut at the stopped position.
1
3
2
hsn2jo-002
Adjusting the Neutral Position of the Piston Pump_002
1.
2.
3.
4.
5.
1
Piston pump
2
Nut
3
Camshaft
Loosen the adjuster nuts.
1
2
hsn2jo-004
Adjusting the Neutral Position of the Piston Pump_003
1
Push-pull cable
2
Adjuster nuts
Adjust the nuts until the end of the push-
pull cable of the pedal side attaches to the
pedal mount, and then tighten the adjuster
nuts.
3
1
2
hsn2jo-005
Adjusting the Neutral Position of the Piston Pump_004
1
Push-pull cable
2
Adjuster nuts
3
Pedal mount
6.
7.
Main body
FS900
Main body
Page 6-7
Adjustment
Summary of Contents for FS900
