![background image](http://html1.mh-extra.com/html/baroness/fs900/fs900_service-manual_3907959115.webp)
Wheel Mounting Shaft
Inspecting the Wheel Installation Shaft
Wear of bearings due to frequent usage and
damage to bearings etc. caused by moisture
entry may prevent smooth rotation of the ball.
Inspect the bearing, wheel installation shaft,
and the like, and replace the parts as
necessary.
Make sure that the bearing is free of wear
and rust, and that the wheel installation
shaft and bearing is free of play.
Make sure that the front wheel housing and
bearing is free of play.
Remove the wheel installation shaft from
the front wheel arm. (See "Removing the
Front Wheel Section" (Page 6-12) .)
Remove the special heat-treated bolt and
spring washer.
Remove the wheel tightening washer and
washer A.
Remove the front wheel housing ass'y.
Remove washer B.
Follow the same steps to remove them from
the other side.
1
7
6
5 4
3 2
6
cvjrk2-001
Inspecting the Wheel Installation Shaft_001
1
Wheel installation shaft ass'y
2
Special heat-treated bolt
3
Spring washer
4
Wheel tightening washer
5
Washer A
6
Front wheel housing ass'y
7
Washer B
Place the front wheel housing ass'y on the
vise.
・
・
1.
2.
3.
4.
5.
6.
7.
Tap the metal rod with a wooden hammer,
and remove the bearing one side at a time.
4
3
2
1
cvjrk2-002
Inspecting the Wheel Installation Shaft_002
1
Vise
2
Front wheel housing ass'y
3
Metal rod
4
Wooden hammer
Caution
Refer to the Tightening Torque Table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening, etc.
Important
Be sure to replace the bearing with a new
one.
Assemble the wheel installation shaft ass'y
following the procedure in reverse.
Note:
Use a bearing driver to drive in the bearing.
8.
9.
Main body
FS900
Main body
Page 6-17
Inspection and repair of each section
Summary of Contents for FS900
