![background image](http://html1.mh-extra.com/html/baroness/fs900/fs900_service-manual_3907959126.webp)
Loosen the bolts securing the rotary plate.
1
2
2rp7t3-001
Adjustment of Rotary Plates_006
1
Bolt
2
Rotary plate
Caution
Evenly install the rotary plate.
Adjust the rotary plate so that there is a
clearance of approximately 5 mm between it
and the brush frame, and then temporarily
tighten the bolts.
A
2
1
2rp7t3-002
Adjustment of Rotary Plates_007
1
Brush
2
Brush frame
A
5 mm
Slowly rotate the rotary plates by hand, and
then follow the same steps to adjust the
remaining rotary plates and temporarily
tighten the bolts.
8.
9.
10.
Caution
Refer to "Tightening torques" (Page 3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Slowly rotate the rotary plates by hand,
check the clearance again and tighten the
bolts.
After making adjustments and tightening the
bolts, tighten all bolts firmly.
Install the brush cover.
Start the engine, rotate the rotary plates, and
then check that there is no contact between
or vibration in the rotary plates and brush
frame.
Adjusting the Bucket
Adjust the clearance between the operating
machine and bucket.
Park the machine on level ground, then
apply the parking brake.
Lower the operating machine.
Stop the engine.
2
4
1
5
3
11rwis-001
Adjusting the Bucket_001
1
Operating machine
2
Bucket
3
Clearance between the operating
machine and bucket
4
Bucket mounting frame
5
Rear roller
11.
12.
13.
14.
1.
2.
3.
FS900
Operating Machine and Mower Units
Page 7-8
Adjustment
Summary of Contents for FS900
