![background image](http://html1.mh-extra.com/html/baroness/fs900/fs900_service-manual_3907959127.webp)
The clearance between the bucket and the
operating machine is 10 mm (0.393 in) for
both the upper area setting value and the
lower area setting value.
2
1
3
4
11rwis-002
Adjusting the Bucket_002
1
Bucket
2
Operating machine
3
Upper area setting value 10 mm
(0.393 in)
4
Lower area setting value 10 mm
(0.393 in)
If the lower area clearance is wrong, loose
the installation bolt until the spring washer
turns lightly.
Loosen the installation bolt in the same
manner on the opposite side.
Move the bucket mounting frame in the
direction of the arrow, and adjust the
clearance to the 10 mm (0.393 in) setting
value.
Caution
Refer to the Tightening Torque Table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening, etc.
Tighten the installation bolts.
4.
5.
6.
7.
8.
Important
Set the left and right adjustment pipes to the
same length.
Adjust the upper area clearance using the
adjustment pipe.
5
3
4
2 1
11rwis-003
Adjusting the Bucket_003
1
Installation bolt
2
Spring washer
3
Bucket mounting frame
4
Direction of movement
5
Adjustment pipe
9.
Operating Machine and Mower Units
FS900
Operating Machine and Mower Units
Page 7-9
Adjustment
Summary of Contents for FS900
