![background image](http://html1.mh-extra.com/html/baroness/fs900/fs900_service-manual_3907959142.webp)
Disengage the left and right slide latches.
1
xsi3tb-003
Change of Brushes_004
1
Slide latch
Remove the brush cover.
1
xsi3tb-004
Change of Brushes_005
1
Brush cover
Remove the bolts securing the brush.
2
1
1
xsi3tb-005
Change of Brushes_006
1
Bolt
2
Brush
Remove the rotary brush.
Install a new rotary brush.
Caution
Evenly install the brush.
6.
7.
8.
9.
10.
Adjust the brush so that there is a
clearance of approximately 5 mm between
its tip and the brush frame, and then
temporarily tighten the bolts.
1
A
2
xsi3tb-006
Change of Brushes_007
1
Brush frame
2
Tip of rotary brush
A
Approximately 5 mm
Slowly rotate the rotary brushes by hand,
and then follow the same steps to adjust
the remaining brushes and temporarily
tighten the bolts.
Caution
Refer to "Tightening torques" (Page 3-5) .
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening etc.
Important
Do not forget to tighten bolts properly.
Slowly rotate the rotary brushes by hand,
check the clearance again and tighten the
bolts.
After making adjustments and tightening
the bolts, tighten all bolts firmly.
Install the brush cover.
Start the engine, rotate the brushes, and
then check that there is no contact between
or vibration in the brushes and brush frame.
11.
12.
13.
14.
15.
16.
FS900
Operating Machine and Mower Units
Page 7-24
Inspection and repair of each section
Summary of Contents for FS900
