Rotary Plate
Change of Rotary Plates
Caution
If the rotary plate operation height is
inadequate, cores will not be properly
collected.
Important
Replace all rotary plates. Otherwise the
weight will become unbalanced and vibration
may occur.
If wear of the rotary plates exceeds 5 mm or if
they are deformed or cracked, replace the
rotary plates.
Move the machine to level ground, and
then apply the parking brake.
Shift the bucket up/down lever to the "UP"
position to raise the bucket.
ON
OFF
OPEN
UP
CLOSE
FREE
PURESS
DOWN
DOWN
UP
1
A
5c6vly-001
Change of Rotary Plates_001
1
Bucket up/down lever
A
Up
Stop the engine.
1.
2.
3.
Important
To keep the position of raised bucket, be sure
to lock it with the cylinder lock.
Remove the cotter pin and round head pin,
and then lower the cylinder lock.
2
1
3
xsi3tb-001
Change of Rotary Plates_002
1
Cotter pin
2
Round head pin
3
Cylinder lock
Insert the round head pin through the holes
in the cylinder lock, and then install the
cotter pin.
2
1
3
xsi3tb-002
Change of Rotary Plates_003
1
Cotter pin
2
Round head pin
3
Cylinder lock
4.
5.
Operating Machine and Mower Units
FS900
Operating Machine and Mower Units
Page 7-25
Inspection and repair of each section
Summary of Contents for FS900
