Important
Be sure to replace the taper bearings, oil
seals, and O-rings with new ones.
Important
Be sure to replace the outer and inner taper
roller bearings as a set.
Apply a profuse amount of grease on the
new taper bearings and oil seals.
Apply grease to the taper bearings until
grease comes out the opposite side.
Apply a profuse amount of grease to the lip
of the oil seal.
2
1
yl7n3f-004
Inspection of Rear Roller_007
1
Taper roller bearing
2
Oil seal
Caution
Refer to the Tightening Torque Table.
Note that the Baroness product warranty may
not apply to defects caused by incorrect or
overtorque tightening, etc.
Install the rear roller ass'y following the
reversed procedure of the procedure 2 to
11.
Note:
Use a bearing driver to drive in the oil seal
and bearing.
Make sure that the roller rotates smoothly
with no play when the roller shaft is fixed.
Apply grease.
Install the rear roller ass'y. (See "Installation
of Rear Roller Assy" (Page 7-22) .)
12.
13.
14.
15.
16.
Operating Machine and Mower Units
FS900
Operating Machine and Mower Units
Page 7-29
Inspection and repair of each section
Summary of Contents for FS900
