![background image](http://html1.mh-extra.com/html/baroness/fs900/fs900_service-manual_3907959039.webp)
Final tightening (Reset)
Fit the preliminary tightened tube onto the
fitting body. Tighten with a spanner to the
point where some resistance is suddenly felt,
then further tighten with the nut for a 1/4 turn.
w7s31b-009
Bite type tube fitting_009
Note:
For direct tightening, use the fitting body to
follow procedures 1 to 5 when using a
temporary tightening tool, and set the zero
point. Further tighten for 1 and 1/4 turn from
the zero point.
w7s31b-010
Bite type tube fitting_010
Reuse of piping
Bite type fitting can be reused if an inspection
finds no flaw or other damage on the sleeve
surface. Done properly, disassembly and
retightening can be carried out up to five
times or so.
Hydraulic system
FS900
Hydraulic system
Page 4-11
General instructions
Summary of Contents for FS900
