![background image](http://html1.mh-extra.com/html/baroness/fs900/fs900_service-manual_3907959065.webp)
Caution
Before starting pressure measurement, make
sure that there are no people around the
machine.
Raise the seat.
Remove the special T PT1/4 PF1/4 screw
cap attached to the up/down cylinder.
2
1
4
3
id1tdw-002
Surface Compaction Circuit_002
1
Brush frame
2
Up/down cylinder
3
Special T PT1/4 PF1/4
4
Screw cap
Prepare a pressure gauge for extremely low
pressure measurements.
1
id1tdw-003
Surface Compaction Circuit_003
1
Pressure gauge for extremely low
pressure measurements
Attach the pressure gauge for extremely
low pressure measurements to the special
T PT1/4 PF1/4.
1.
2.
3.
4.
Secure the pressure gauge for extremely
low pressure measurements to the main
frame using bands.
Note:
Route the hydraulic hose in positions that
will not cause the hose to be pinched by the
seat.
1
2
3
id1tdw-004
Surface Compaction Circuit_004
1
Pressure gauge for extremely low
pressure measurements
2
Bands
3
Special T PT1/4 PF1/4
Return the raised seat to its original
position.
Start the engine, and rev it up to the
maximum rpm.
The normal pressure is 0.98 MPa (10
kgf/cm
2
) (142.13 psi).
Position the brush up/down lever to the
down side, and the roller press lever to the
rear side.
5.
6.
7.
8.
Hydraulic system
FS900
Hydraulic system
Page 4-37
Measurement
Summary of Contents for FS900
