Brake
A worn brake shoe will increase the amount of
brake pedal depression, and may cause the
pedal to touch the floor or result in uneven
braking. Inspect the brake accordingly.
Adjust the brake shoe clearance to be even on
both sides. A brake shoe is gradually worn
down like an eraser as the brake is applied.
Check the remaining shoe amount upon
inspection and replace as needed.
Inspection of Brake
Adjust the clearance of the brake shoe so that
the left and right sides are even. Brake shoe
wears out gradually as the brake is used just
like an eraser. Check the remaining amount at
the inspection. Replace if it is too small.
Disassembly and assembly of brake
A brake shoe can be replaced with this
equipment fitted.
1
z2sgi8-001
Disassembly and assembly of brake_001
1
Shoe
Remove the springs on both sides.
Note:
They are different in size.
1
1
z2sgi8-002
Disassembly and assembly of brake_002
1
Spring
Turn the spring holder 90 degrees while
pressing it and remove it.
Remove the spring and hold pin.
2
1
3
a1y6z3-003
Disassembly and assembly of brake_003
1
Spring support
2
Spring
3
Hold pin
1.
2.
3.
FS900
Main body
Page 6-18
Inspection and repair of each section
Summary of Contents for FS900
