LM315GC (for field mowing)
You can adjust the rear roller by eight
stages.
Attach the rear roller in a position that
suits your work requirements within the
cutting height range.
Note:
The figure below shows the position of
the rear roller bracket with a new reel
cutter using 3.0 mm bed knife.
The lowest cutting height differs with
thickness of the bed knife. "Cutting
Height and Blade Thickness of Bed Knife
(Bottom Blade)" (Page 4-20)
1
2
3
A
B
C
D
E
F
G
H
3kws2a-011
Adjustment of Rear Roller_004
1
Mower frame
2
Rear roller bracket
3
Rear roller
A
10.0 - 13.0 mm (0.394 - 0.512 in)
B
13.0 - 17.0 mm (0.512 - 0.669 in)
C
17.0 - 22.0 mm (0.669 - 0.866 in)
D
22.0 - 28.0 mm (0.866 - 1.102 in)
E
28.0 - 33.0 mm (1.102 - 1.299 in)
F
33.0 - 37.0 mm (1.299 - 1.457 in)
G
37.0 - 40.0 mm (1.457 - 1.575 in)
*
H
40.0 - 43.0 mm (1.575 - 1.693 in)
Not recommended by manufacturer.
1.
*
Adjustment of Front Roller
Set the slide caliper to the required cutting
height, adjust the neck position of the
cutting height screw of the cutting height
gauge and securely lock with a fly nut.
Loosen the nut which fixes the roller
bracket of the front roller.
Apply the cutting height gauge to the front
and rear rollers at each edge of left and
right of the mower unit.
5
4
2
6
2
7
1
3
8
3kws2a-010
Adjustment of Front Roller_001
1
Cutting height
2
Cutting height gauge
3
Cutting height screw
4
Nut
5
Front roller
6
Rear roller
7
Bed knife (bottom blade)
8
Roller adjuster
1.
2.
3.
Handling Instructions
LM315GC
Handling Instructions
Page 4-17
Adjustment Before Operating
Summary of Contents for LM315GC
