Page 5/8
DIN Rail mounting
The DIN-Rail is pre-installed on the industrial Ethernet switch from the factory. If the DIN-Rail is not on the
industrial Ethernet switch, please see the Figures below to learn how to install the DIN-Rail on the switch.
Follow the steps below to learn how to hang the industrial Ethernet switch.
Step 1.
Use the screws to install the DIN-Rail bracket on the rear side of the industrial Ethernet switch.
Step 2
To remove the DIN-Rail bracket, do the opposite from Step 1.
Step 3
After the DIN-Rail bracket is installed on the rear side of the switch, insert the top of the DIN-Rail on to the track
as shown below.
Step 4
Lightly pull down the bracket on to the rail as shown below in Figure 3.3.
Step 5
Check if the bracket is mounted tightly on the rail.
Step 6
To remove the industrial Ethernet switch from the rail, do the opposite from the above steps
