Barracuda CloudGen Firewall
5 / 7
Status LED front side -
GREEN
Steady
After a hotfix installation, the
LED turns to green until the
next reboot in case the hotfix
installation was successful. This
feature requires firmware 7.1.3
or higher OR 7.2.2 or higher.
When installing from USB drive:
after 3 beeps, pull out the USB
and reboot the box by switching
power off and back on.
Box is running normally, or
installation has finished
successfully.
Status LED front side -
GREEN
Blinking
slowly (1/s
interval)
Normal installation
Appliance is either booting,
shutting down, or
performing a system
update.
Status LED front side -
RED
Steady
The LED turns to red until the
next reboot in case the hotfix-
or USB installation failed.
Appliance is halted and may
be disconnected, or an error
occurred preventing the
appliance from entering the
up state.
Disc LED - YELLOW
Blinking
Appliance is reading or writing
on storage.
Appliance is accessing the
internal storage.
Port LEDs -
GREEN/YELLOW
Left
blinking
Data transfer – Yellow (10/100
Mbps)
Port in use.
Right
steady
-
Port is on.
Port LEDs 6 and 7 for
Optical Fiber ports -
GREEN
Steady
-
Port is on.
Blinking
Data transfer
Port is in use.
PSU LEDs - GREEN
Steady
PSU modules connected and
running
Power supply unit is up and
running.
Off
Power defective, standby, or
shutdown
Power supply unit is off or in
standby mode.
Acoustic Signal
Frequency
Meaning
Beep
1 time
(1sec.)
The appliance is booting.
Beep/Jingle
3 times
(1sec.-1sec.-1sec.)
Installation was completed successfully. The appliance is
halted for a reboot. After reboot, one beep will again indicate
booting.
LED and acoustic signals may vary between different appliance models.
Serial Console Port