Reference / FAQ
Rack Installation for Barracuda CloudGen Firewall F800 Revision C and F900 Revision A,B
7 / 11
Place the rail as shown below.
1.
Press the safety lock tab and pull the inner rail from the middle rail until they completely
2.
separate.
Attaching the Inner Rails to the System
Use the following procedures to attach the inner rails to the chassis.
Position the inner rail adjacent to one side of the system’s chassis. Make sure that the safety
1.
lock tab faces out, and that the notched end of the rail is located at the rear of the unit as
shown in the following diagram.
Align the screw holes in the rail and the mounting holes on the chassis and then attach the
2.
inner rail to the system with three of the short flat-head screws (A).
Attach the front ear bracket to the system.
3.
Repeat these steps to attach the other inner rail and front ear bracket to the other side.
4.
