Barracuda CloudGen Firewall
4 / 6
Status LED front side -
GREEN/RED
Off
Installation has not initialized far
enough for LED control when
installation is started.
-
Status LED front side -
GREEN
Steady
After a hotfix installation, the
LED turns to green until the next
reboot in case the hotfix
installation was successful. This
feature requires firmware 7.1.3
or higher OR 7.2.2 or higher.
Box is running normally, or
installation has finished
successfully.
Status LED front side -
GREEN
Blinking
slowly (1/s
interval)
Normal installation.
Appliance is either
booting, shutting down, or
performing a system
update.
Status LED front side -
RED
Steady
After a hotfix installation, the
LED turns to red until the next
reboot in case the hotfix
installation failed. This feature
requires firmware 7.1.3 or higher
OR 7.2.2 or higher.
Appliance is halted and
may be disconnected, or
an error occurred
preventing the appliance
from entering the up state.
Disc LED - YELLOW
Blinking
Appliance is reading or writing
on storage.
Appliance is accessing the
internal storage.
Port LEDs -
GREEN/YELLOW
Left blinking
Data transfer – Yellow (10/100
Mbps)
Port in use.
Right
steady
-
Port is on.
Port LEDs 3 for Optical
Fiber port - GREEN
Steady
Port is on.
Blinking
Data transfer.
Port in use.
Port LEDs 6 and 7 for
Optical Fiber ports -
GREEN
Steady
-
Port is on.
Blinking
Data transfer.
Port is in use.
Acoustic Signal
Frequency
Meaning
Beep
1 time (1sec.)
The appliance is booting.
Beep/Jingle
3 times (1sec.-1sec.-1sec.)
Installation was completed successfully. The appliance
is halted for a reboot. After reboot, one beep will again
indicate booting.
LED and acoustic signals may vary between different appliance models.
Serial Console Port
In order to establish a console connection to the appliance using an RS232 serial cable, you need to
