30SG OPERATOR’S MANUAL 11/25/13 Page 5 of 24
SAFETY INSTRUCTIONS OVERVIEW (continued)
WARNING
: Contact with the cutter wheel while in operation will cause serious injury or even
death. The teeth of the cutter wheel are sharp. Avoid contact even when the wheel is not moving.
Avoid inclines if at all possible.
WARNING
: Navigating on any incline increases the danger of the machine losing traction or
rolling over, especially if the surface is wet. If you lose control, get out of the way immediately to
avoid personal injury. Navigation on inclines should be especially slow and turns very gradual. Refer to
the incline diagram in the section, “GROUND TRANSPORT”.
Avoid operating adjacent to drop-offs or embankments.
Keep away from tracks to avoid being crushed.
WARNING
: Being run over by the machine will cause injury.
Always leave machine parked on a level surface.
WARNING
: Do not park on incline. Move the machine to a level surface and set the parking brake
located behind the left hand track motor. Move the handle down to engage the brake.
Do not leave machine unattended with the engine running.
Do not operate machine near any source of flammable dust or vapors.
WARNING
: Sparks from the engine exhaust can cause an explosion or fire in a flammable or
explosive atmosphere. Fuel fumes can catch fire or explode.
Do not operate machine near flames or sparks.
WARNING
: Fuel fumes can catch fire or explode. If fuel is spilled, do not attempt to start engine
but move the machine away from the area of spillage and avoid creating any source of
ignition until the vapors have dissipated.
Shut off engine and allow it to cool before refueling.
WARNING
: Fuel fumes can catch fire or explode. Refuel outdoors and do not smoke when
refueling. Do not refuel near a source flames or sparks. Always store fuel in containers
specifically designed for this purpose. Add fuel before starting engine. Never remove the cap
on the fuel tank or add fuel while the engine is running or when the engine is hot.
WARNING
: Replace all fuel tank and container caps securely.
Do not touch the engine, muffler, or any of the hydraulic components until cool.
WARNING
: Muffler and engine get hot enough to cause serious burns. For the safety of yourself
and others, allow enough time for the engine, muffler, and the hydraulic fluid to cool completely
before performing any cleaning or maintenance.
WARNING
: Stay clear of the articulation area while the engine is running.
