825TKL OWNER’S MANUAL 10/17/22 Page 3 of 22
TRACK LOADER INSTRUCTIONS UPON DELIVERY
Upon delivery, check for freight damage and any missing items. If there is damage, notify the carrier
and Barreto Manufacturing immediately
and make sure to document there was damage on the
delivery receipt.
Please take pictures of any damage immediately if possible before unpacking crate.
Remove machine from shipping crate.
When documentation refers to “right side” or “left side”, it is relative to the operator’s position with
both hands on the controls.
SERVICE INFORMATION
HYDRAULIC SYSTEM:
•
Your Track Loader should arrive with approximately 11 U.S. gallons (41 liters) of tractor
transmission / hydraulic fluid in the tank. Shipping regulations may prohibit shipping with the
hydraulic fluid. Check the reservoir level using the sight gauge located at the back of the
machine above the standing platform. If required, add tractor transmission / hydraulic fluid to the
reservoir. For machine use in ambient temperatures b32°F (0°C) and +90°F (32°C)
hydraulic fluid ISO 68 is recommended. If the machine is operated at temperatures below +32°F
(0°C) then hydraulic fluid ISO 46 is recommended.
•
Recheck oil level after Track Loader has been run and oil has circulated through the components.
Routinely check level thereafter.
•
Change hydraulic fluid filters after the first 50 hours of use. Change it every 200 hours thereafter.
•
There are two hydraulic filters, one by the operator platform and one at the front of the unit by the
hydrostats. See page 11 for details.
•
Add approximately one quart (1 liter) of hydraulic fluid to reservoir with each filter changed.
•
Discard the old filter according to environmental standards in your geographic area.
•
Check all hydraulic fittings for leaks and tighten if necessary.
WARNING - Running the Track Loader without hydraulic fluid will cause serious damage to the
hydraulic pump. ENSURE THAT THE RESERVOIR FLUID LEVEL IS VISIBLE IN THE SIGHT
GAUGE BEFORE STARTING THE MACHINE.
IMPORTANT
- The engine on the Barreto Track Loader may or may not have been serviced prior to
shipping. Shipping regulations may prohibit shipping with fuel or oil in the engine. Check levels and
add oil and fuel as required before starting engine. Service the engine according to the engine
owner’s manual before starting.