MANUAL SWING GATE
Installation Procedure
IP36 – MSG5000 © Copyright 2016
www.barriergroup.com.au
Optional Mounting Post
& Receiver Post
Receiver Post
(C90)
Mounting Post
(C140 or CS150)
WARNING
This gate MUST close onto a
suitable post or structure to prevent
damage caused by forcing gate past
its stopping point.
Important information.
Read carefully.
Keep this information for further reference.
WARNING
The gate will not provide optimum performance unless it is installed correctly. For satisfactory gate operation please follow
the instructions carefully.
NOTE:
No guarantee will be given or responsibility accepted by the manufacturers if the gate is not installed as instructed.
Barrier Group
do not
warrant the work of 3rd party contractors.
BEFORE YOU START
1. The installer must ensure the desired mounting point for the gate is level, plumb and rigid.
2. Use fixings appropriate to the material into which they are being fixed (not included).
3. Check all parts are included. Contact Barrier Group immediately if you are missing a piece.
