IP56_Installation Procedure - Telescopic Boom Gate © Copyright 2019
www.barriergroup.com.au
STEP 3:
Adjust boom length to suit desired opening. Secure the length using the
thumb screw. Attention: Do not over-tighten! Test gate operation.
Important information.
Read carefully.
Keep this information for further reference.
WARNING
The gate will not provide optimum performance unless it is installed correctly. For
satisfactory gate operation please follow the instructions carefully.
NOTE:
No guarantee will be given or responsibility accepted by the manufacturers if the gate
is not installed as instructed. Barrier Group
do not
warrant the work of 3rd party contractors.
BEFORE YOU START
1. The installer must ensure the desired mounting point for the gate is level, plumb and rigid.
2. Use fixings appropriate to the material into which they are being fixed (not included).
3. Check all parts are included. Contact Barrier Group immediately if you are missing a piece.
AFTER INSTALLATION CARE
Barrier Group recommends that you check the operation of your gate at least every six
months (more regularly in extreme environments or frequent use). It is natural for spring
assistance unit to lose tension over time. Adjustment may be required.
