Ceiling or End Mount (Fig. 1a)
1. Remove the lens by removing the (6) screw caps and the (6) screws with O-rings and set all aside.
2. Remove the EXIT template and diffuser and set both aside.
3. Remove the inner frame by removing the (4) screws and set aside.
4. Punch out desired knockouts located in the top or side of the enclosure.
5. Remove the small rectangular gasket with two holes from the gasket sheet and position it between the enclosure and
the canopy, aligning the two holes in each part.
6. Secure the canopy to the enclosure with the (2) sets of threaded bushings and nuts, ensuring that the canopy has a
proper seal with the enclosure.
7. Remove the square gasket from the gasket sheet, then route wires out through the canopy, followed by the mounting
plate and the square gasket. Ensure that the mounting plate is in the correct orientation (see Fig. 1b).
8. Make electrical connections; see
Electrical Connections
section.
9. Secure the mounting plate to the J-box.
10. Secure the canopy to the mounting plate, ensuring that the canopy has a proper seal with the mounting surface.
11. Connect the battery, if included.
Fig. 1a
J-Box
Square Gasket
J-Box Mounting
Screw
Diffuser
Screw
Cap
EXIT Template
Lens
O-Ring
Stainless Steel
Screw
Enclosure
Inner Frame
Frame
Screw
J-Box Mounting
Plate
Canopy
O-Ring
Stainless Steel
Screw
Small Rectangular
Gasket
Threaded
Bushing
Mounting Plate “feet” face
away from the J-Box
Fig. 1b
NXFX Series
Installation Instructions
10070226
R
EV 1 - 08/20
2
800-533-3948 www.barronltg.com
