TLED-I
INSTALLATION INSTRUCTIONS
800.533.3948
•
www.barronltg.com
20070001 Rev 2 11/13
2
Fig. 3
(2) field supplied
screws
level bubble
4. In order to facilitate installation use the attached lanyard to hang the fixture prior to connecting the leads. (Fig. 3)
5. Electrical connections should be made inside junction box. Cap all unused leads to prevent shorting.
This fixture auto adjusts for voltages between 120VAC - 277VAC. (Fig. 4)
6. Align the canopy against the mounting plate. Caution should be taken when mounting fixture as not to pinch
wire leads.
7. Secure fixture by tightening the (2) allen set screws to lock the mounting plate to canopy.
8. For wet locations, caulk between canopy and mounting surface to prevent water from entering the fixture from behind.
CAUTION:
This fixture must be mounted in the lens down position. DO NOT TOUCH THE SURFACE OF THE LEDs.
connect lanyard
white (neutral)
black
(120V-277V)
green
(ground)
Fig. 4
lanyard
