w w w . b a r s k a . c o m
w w w . b a r s k a . c o m
2
3
Biometric Safe
Biometric Safe
WARNING
- New Safe is in Factory Default mode; ANY fingerprint can open the safe.
Only a successfully registered Fingerprint(s) can terminate Factory
Default mode.
- Register at least two different fingerprints and test a few times before
closing the safe door.
- Test with a non-registered fingerprint. If the safe opens, the safe is still in
Factory Default mode.
- Avoid leaving safe door open and unattended; it will allow unauthorized
individuals to add their fingerprints and/or reprogram the safe, gaining full
access to the safe and the contents.
- Test the Emergency Keys and store them in a secure place, NOT inside
of the safe.
- To maximize the security and performance of the safe, test registered
fingerprints every 6 months.
- If user resets the safe to Factory Default mode: ANY fingerprint can
open the safe.
- Test and make sure the safe works properly before mounting.
Once tested, mount safe before use.
- Keep out of reach of children.
- Failure to follow these warnings could result in serious injury or death.
NOTE: BARSKA is not responsible for any damage or lost contents in the
safe due to moisture.
NOTE: BARSKA is not responsible if the safe is stolen or contents in
the safe.
Read all instructions before using this safe
Table Of Contents
Parts Of The Safe
4
Getting Started
5
Install Batteries
5
Fingerprint Registration
5
Test Non Registered Fingerprints
6
Interior Light
6
Close/Open Safe Door
6
Close/Open Interior Compartment
6
Beep Sound Options
7
Open Safe With Emergency Key
7
Delete All Stored Fingerprints / Reset to Factory Default Mode
7
Low Battery Warning
8
Care And Maintenance
8
Mounting Instructions
9
Warranty
10
