7
Testing the operation of the lock
1. Rotate the inside handle lever and hold. Ensure that the latch is fully
retracted and flush with the latch face plate. Release the inside
handle lever, the latch should be fully extended.
2. After batteries putting in the lock, it is going in a normal situation if the
latch is retracted inside once rotating the indoor handle and holds it,
and also the latch is fully extended once releasing the indoor handle.
Please see the following diagrams in Figure 1.
3. Place your finger on the fingerprint sensor, you should see the sensor
is flashing with red LED, the number display shows “- -”, a long beep,
a green light and a motor clutch sound. Rotate the front handle lever
and hold. Ensure that the latch is fully retracted.
4. With the door open, verify functionality of the mechanical key override
as shown. Take off the front handle lever, insert the mechanical key,
turn the key to vertical position then rotate the handle bar. Ensure the
latch is fully retracted.
How to use mechanical key
8
Figure 1
