Technical data subject to change without notice
01-3400-7D0001/REV-A-12-2022/ESS-461926
3 / 8
BARTEC Operational Instructions – Control and signal device actuators and accessories
Safety Instructions
The control and signal device actuators may be used only within
the specified service and operating temperature.
Utilisation in areas other than those specified and the
modification of the product by any one other than the
manufacturer is not permitted and will exempt BARTEC from
liability for defects and any further liability .
Incorrect installation can cause malfunctioning and the loss of
explosion protection
Only service technicians who are authorized to work in
potentially explosive atmospheres may do any of the assembly,
disassembly, installation, commissioning, maintenance, and
fault clearance work.
The generally applicable statutory rules and other binding
directives relating to workplace safety, accident prevention and
environmental protection must be observed.
When setting up or operating explosion-resistant electrical
systems, IEC/EN 60079-14 and all relevant installation and
operating regulations must be observed.
The control and signal device actuators may be used only if it
is in a clean and undamaged condition. It is not permissible to
modify the actuators in any way.
Marking
Particularly important points in these instructions are marked
with a symbol:
DANGER
indicates a hazardous situation which, if not avoided, will
result in death or serious injury.
WARNING
indicates a hazardous situation which, if not avoided, could
result in death or serious injury.
CAUTION
indicates a hazardous situation which, if not avoided, could
result in minor or moderate injury.
NOTICE
is used to address practices not related to personal injury.
NOTE
Important instructions and information on effective,
economical and environmentally compatible handling.
Standards conformed to
Please see the Attestation of Conformity.
Transport, Storage
NOTICE
Control and signal device actuators damage through
incorrect transport or incorrect storage.
• Transport and storage is permissible in original packaging
only.
• Store the control and signal device actuators in a dry place.
Assembly and Commissioning
WARNING
Risk of injury due to incorrect proceedings.
• Only authorized and qualified personnel may do any of the
assembly, disassembly, installation and commissioning
work.
• Use suitable tools.
Assembly/Disassembly
NOTICE
Damage to control and signal device actuators due to
incorrect installation dimensions.
• The minimum spacing between the mounting holes must be
observed.
NOTE
Installation dimensions and assembly drawings, see page 5.
Commissioning
Before commissioning, check that:
– The device has been installed correctly.
– The device is not damaged.
Installation
The control and signal device actuators must be installed as
a stationary unit. The following schedule of limitation must be
observed:
– When the components are installed to electrical equipment,
the service temperature of the components of -55 °C to
+70 °C (-67 °F to +158 °F) must not be exceeded.
– The control and signal device actuators, type 07-3400-
A***/**** (push button), and type 07-3400-P***/****
(mushroom push button), must only be used in combination
with the ComEx switch module type 07-332*-****/**** or
type 07-3382-****/****.
