Safety
Ex p control unit
Motor Purge Controller
Page 14 of 96
01-37A2-7D0003_Operating instructions_MPC_20210923_0_en.docx
Rev. 0
Aggressive cleaning agents
When choosing the right cleaning agent, it is essential to ensure that it is
suitable, otherwise seals and connections may be damaged. Flammable
products are generally not permitted.
Danger to health in the event of improper disposal
According to the European WEEE directive, electrical and electronic devices may
not be disposed of with household waste. Their components must be recycled or
disposed of separately because toxic and hazardous components can cause
lasting damage to health and the environment if not disposed of properly.
As consumers, according to the ElektroG, you are obliged to return electrical and
electronic devices at the end of their service life to the manufacturer, the point
of sale or to public collection points set up for this purpose. Details on this can
be found in the respective state law. The symbol on the product, the operating
instructions and/ or the packaging refers to these provisions. By separating the
material, as well as recycling and disposing of old devices, you are making an
important contribution towards protecting our environment.
2.6
Obligations of the operating company
The operator undertakes to only allow people to work with and on the APEX /
SILAS control unit who:
are familiar with the basic regulations on safety and accident prevention
and have been instructed in the use of the APEX and SILAS control unit;
have read and understood the documentation, the safety chapter and the
warning notices.
The operating company will check that the safety and accident prevention
regulations applicable in the respective application are complied with.
2.7
Instructions for use
Overvoltage category II of the non-intrinsically safe circuits according to
IEC 60664-1 must be observed
The warning "WARNING - DO NOT OPEN UNDER VOLTAGE" must be part of
the external marking of the entire electrical device, or the housing has a
locking system so that the fuses are not live when they are replaced.
