BCS3600
ex
series
Hand-held scanner and accessories
Annex
Subject to technical changes.
April 2022 / Revision C
153/164
14
Annex
14.1
Recommended converters
BARTEC has used converters for testing in the laboratory and can recommend them.
The installation and setup is according to the manufacturer's instructions.
Install the drivers according to the instructions.
It is important that the interface parameters on the PC and on the BCS36x8ex
system are set identically.
On the PC, the settings can be made using the Device Manager or a software
application.
On the scanner or universal supply module, the settings can be made as described
in this user manual.
On the PC side a software application (e.g. Software Keyboardwedge) or a terminal
program is required to display the serial data.
Based on the principle of operation, it should be possible to use all commercially available
converters.
However, BARTEC cannot guarantee this, as not all properties and their effects can be
considered and tested.
The basic requirement for a converter to function is that it supports one of the available
BCS36x8ex system interfaces.
Conversion from interface (e.g. USB-SPP, RS232, RS422 or RS485) to interface
(e.g. USB-HID, TTY, and others)
Conversion from interface (e.g. USB-SPP, RS232, RS422 or RS485) to protocol
(e.g. Modbus; Profibus, and others)
The available interfaces depend on the selected system of the BCS36x8
ex
.
Please refer to the relevant product/part specification to find out which interfaces are
available.
Summary of Contents for BCS3600ex Series
Page 1: ...Hand held scanner BCS3600ex series User Manual...
Page 2: ......
Page 4: ......
Page 173: ......
