Scope :
USER MANUAL
DE8-BC Ex d Complete Enclosure
Date:
20.03.2019
Ver.:
3
QA Code:
5
Checked by:
E.T.
Approved by:
S.Gr.
Page:
3
of
7
Document no. :
13614
The passing on and copying of this document and the use or communication of it’s contents are forbidden without express authority.
Offenders are liable to payment of damages. All rights are reserved in the event of the registration of a patent .
Meaning of symbols
This symbol means a hazard and precaution to be taken
Safety instructions
The device must be installed, used and maintained in accordance with the following
standards:
•
IEC/EN 60079-1 (Explosive atmospheres - Part 1: Equipment protection by
flameproof enclosures "d")
•
IEC/EN 60079-14 (Explosive atmospheres - Part 14: Electrical installations design,
selection and erection)
•
IEC/EN 60079-17 (Explosive atmospheres - Part 17: Electrical installations inspection
and maintenance)
•
IEC/EN 60079-31 (Explosive atmospheres - Part 31: Equipment dust ignition
protection by enclosure "t")
•
Decrees, orders, laws, directives, circulars, applications, standards, state of art and
other documentation relating to its installation site
It is forbidden to change anything (components, installation, wiring ...) without the
prior written consent of Bartec Technor.
We cannot accept any responsibility for failure to observe these regulations:
•
Make sure of the compatibility between the information on the nameplate, the
explosive atmosphere present, the area of use and ambient temperatures on surfaces
•
Any damage on the device can cause the explosion-proof protection to become
ineffective
•
The installation of the enclosure must be done in the state of the art in the technical
domains and only by qualified, competent and empowered personnel
•
A defective or abnormal use as well as the non compliance with the instructions of the
present document exclude any clause of guarantee and do not engage our
responsibility
•
The use of the device in case of excessive deposits of dusts superior at 50mm
according to EN / IEC 60079-31 is not authorized
•
Liability for manufacturer traceability is ensured only at the first known delivery
destination (serial number specified on the certification label)
•
It is also required to observe the regulations of the country of use
•
The doors of the DE8-BC enclosures are relatively heavy, to avoid sagging of the
doors, potentially making the door not align with the flange of the enclosure, the doors
shall be closed and secured during any moving and shfting of the enclosures. It is
also strongly advisable to close and secure the doors when the daily working shift is
over
•
The flame paths of the doors and of the flanges of the enclosures must be well
protected whilst work is performed and ongoing inside the enclosures
Transport, storage
•
Check it the product has been damaged during transport. If any damage is observed,
do the statutory reserves to the carrier
•
Do not put damaged products into service
