7" Industry Tablet
- Lumen X7
Type B7-A23.-2…/……..
Operation
Subject to technical changes.
03/2016
EN 37/61
Radio transmitters for RLAN devices
The operation of RLAN devices (5 GHz) is subject to the following restrictions in Canada:
−
Frequency range restricted to 5.60 GHz to 5.65 GHz.
This device complies with the radio standard RSS 210 of the Industry & Science Canada.
The operation of the device is based on the following two conditions:
−
The device may not cause any damaging interference.
−
The device must absorb all receiving interference including interference which may
lead to undesirable operation.
Label symbol “IC:” before the radio certification merely means that the technical data of
Industry Canada have been satisfied.
6.5
Electromagnetic fields
Reduction in high frequency energy – intended use
Only use device in compliance with the supplied instructions.
International
The device complies with the internationally recognised standards for the recommended
maximum values for electromagnetic fields of radio devices. Information on
“internationally“ recommended maximum values for electromagnetic fields is provided in
BARTEC’s Declaration of Conformity at
http://www.bartec.de/
.
Europe
Portable devices have been specially tested for operation in direct body proximity. Use
exclusively belt clips, holsters and similar accessories which have been tested and
approved by BARTEC to ensure compliance with the EU regulations.
USA and Canada
Declaration on joint use
To comply with the FCC guidelines with respect to exposure to high frequency energy, the
aerial for this transmitter should not be used in the direct vicinity of, or in an operation unit
with, other transmitters/aerials with the exception of those approved in this document.
The Lumen X7 Industry Tablet should only be worn close to the body when turned off.
Portable devices have been specially tested for operation in direct body proximity. Use
exclusively belt clips, holsters and similar accessories which have been tested and
approved by BARTEC to ensure compliance with the FCC regulations. Belt clips, holsters
and similar accessories of third manufacturers may not satisfy the FCC requirements for
the recommended maximum values for electromagnetic fields and should not therefore be
used.
Micro SD card
The Micro SD card slot provides a secondary, non-volatile memory. The slot is located on
the side of the Industry Tablet. Further information is provided in the documentation
supplied with the card. Observe the manufacturer’s recommendations on use.
Summary of Contents for Lumen X7 B7-A23.-2 SERIES
Page 2: ......
Page 6: ...empty...
