ULTRASAMPLER® sample collection system
158
Measuring System MAK TIGER 3003 Service manual, SA 131128, 10.03.2020
Terminal
Signal name
Colour
Connected to
39
40
41
+24 V on-board power supply from terminal 54
AGND on-board power supply from terminal 55
+44 V operating voltage for sampler motor for in-
dividual samples, supply from terminal 56
rd 1.5 mm²
bu 1.5 mm²
bk 1.5 mm²
Sampler motor for
whole tank sample
42
43
44
45
46
47
48
49
50
51
Signal M-Up, bottle lifting motor
Signal M-Down, bottle lifting motor
Signal M-Out, magazine discharge motor
Signal M-In, magazine infeed motor
Signal M-Star, star drive motor
Signal P-Star, self-holding contact for star drive
Ground reference potential for P-Star signal
Signal P-Star, check-back signal
+24 V on-board power supply for bottle drive
GND on-board power supply for bottle drive
Shielded connection for bottle drive channel
bn
rd
ye
gn
pk
vt
gy/wh
Wire jumper
bk
bn/wh
Bottle drive
Wires according to colour for type
6774-10
IN 7 (terminal 32)
52
53
Shielded on-board power supply connection
+24 V on-board power supply entry
GND on-board power supply entry
Vehicle
Vehicle battery-
54
55
56
+24 V on-board power supply exit
AGND on-board power supply exit
+44 V operating voltage output for sampler 1
rd 1.5 mm²
bu 1.5 mm²
bk 1.5 mm²
Terminal 39, sampler circuit board
Terminal 40, sampler circuit board
Terminal 41, sampler circuit board
Annotation:
1. Insulate other pigtail leads individually for FLM, type 6826 (rd, wh, bu);
these are not needed.
2. The digital inputs IN 7 (star in position) and IN 8 (bottle down) are re-
served exclusively for the bottle drive signals.
3. This is the standard assignment. Any configuration is basically possible.
Note:
On configuration of "3003", input IN 6 is strictly reserved for "Bottle in po-
sition".
