Operation and Installation Manual PBTC-200
21-54C3-7D0001/-
04/2021-EHT-441168
Notice:
Technical data subject to change without notice.
No claims for damage arising from alternations, errors or misprints shall be allowed.
Page 5 / 45
HTSB-Heating system
IECEx SIR 16.0035
Ex e IIC T2, T3 Gb
Ex tb IIIC T200°C ,T300°C Db
SIRA 16 ATEX 3099
II 2G Ex e IIC T2, T3 Gb
II 2D Ex tb IIIC T200°C ,T300°C Db
2.3
Reasonably foreseeable Misuse
The following activities are a misuse of the product and are not allowed:
Use of the junction box with thermostat module for purposes other than those described in the intended use
Don't observe the maximum permissible heating circuit length, the data sheet of the heating cable type or the Design
Guide
Installation, commissioning, operation, maintenance or disposal by unauthorised or unqualified personnel
Work on live parts or circuits without switching off the junction box with thermostat module or the system
Change, removal or obscuring of signs, notices or warnings
Use of system components that are not approved for use
Commissioning of damaged or faulty system components
Technical modification of the junction box with thermostat module
Non-compliance with the approval and marking of the heating system
The operation of the Electronic Thermostat Module is also considered as misuse
Without properly designed overcurrent protection device
With not approved heating cable or more than one heating cable
Outside defined maintenance and ambient temperature
With unsealed or unsuitable CAK seal
no replacement of the CAK seal after dismantling the heating cable
2.4
Personal Qualification
The junction box with thermostat module may only be handled by qualified personnel in all phases of its life.
The junction box with thermostat module may only be transported by instructed and qualified personnel with special knowledge of
transport.
The system design, installation/assembly, commissioning, operation, maintenance, decommissioning and re-commissioning of the
junction box with thermostat module may only be carried out by trained, instructed and qualified personnel with specific expertise in
the electrical engineering.
Disposal of the junction box with thermostat module may only be carried out by trained, instructed and qualified personnel with
specialist knowledge of disposal.
For system planning, installation/assembly, commissioning, operation and maintenance/servicing, the requirements for personnel
qualification according to DIN/EN 60079-14 must also be observed.
Summary of Contents for PBTC-200
Page 2: ......
