TC77
ex
-NI
- Touch Computer
Type B7-A26*-***3/********
Operation
Subject to technical changes.
01/2021
27/36
Change battery - work steps:
The device provides a Hot Swap mode where you can replace the battery without
powering off the device. Replace the battery within two minutes. After two minutes the
device reboots and data may be lost.
ATTENTION
Incorrect handling may cause damage to property!
Use only batteries which have been tested or certified by BARTEC for this
purpose.
If the battery change takes longer than 2 minutes, switch off the TC77
ex
-NI with
function "Power Off" before removing the battery. Mistakes when removing the
battery can cause data loss.
After replacing the battery, wait 15 minutes before using Battery Swap again.
1.
Remove any accessory attached to the device.
2.
Press the Power button until the menu appears.
3.
Touch Battery Swap.
4.
Follow the on-screen instructions.
5.
Wait for the LED to turn off.
6.
If hand strap is attached, slide the hand strap clip up toward the top of the device and
then lift.
7.
Press the two battery latches in.
Summary of Contents for TC77ex-NI
Page 1: ...Touch Computer TC77ex NI Quick Start Guide...
Page 2: ......
Page 4: ......
Page 43: ......
