V1.2 TECH550PRO
Page 18
June 2022
TECH550PRO USER GUIDE
P
ROGRAMMABLE
S
ENSOR
The “Programmable Sensor” Point on the service menu enables the function of programming aftermarket replacement
sensors like the RITE-SENSOR®, HUF IntelliSens® or the Schrader EZ-sensor®. Even when they are already mounted in a
wheel or programmed to another vehicle. The user can choose from a selection of sensors which match the preselected
MMY. At which point the user has the ability to create or copy a sensor. Note- the sensor must be read before copying.
Copy Sensor Set
Used to Copy/Clone a winter tire set with the same ID´s as the summer tire set.
Requires the reading of the old sensor to program the same ID on the replacement
sensor to avoid the relearning process.
Create ID
Used to create a single sensor with a new ID. Can be repeated as many times as
requested. The ID needs to be relearned to the vehicle’s ECU. The following pages will
describe this procedure.
Copy/Clone ID
Used to Copy/Clone a single ID. Can be repeated as many times as requested. Requires
the reading of the old sensor to program the same ID on the replacement sensor to
avoid the relearning process.
Enter ID Manually
Used to create a Sensor with a new ID that can be typed in manually. This option only
appears for some sensors. If it is not possible to copy the ID, enter the same ID
manually, which is written on the sensors body.
Copy Using stored
data
Gives you the option of using stored IDs either read from the TPMS sensors or from the
vehicle OBD
The current coverage list is available at
https://www.bartecusa.com/tpms-tool-coverage-charts
Recommended sensor position for programming:
