V1.2 TECH550PRO
Page 2
June 2022
TECH550PRO USER GUIDE
I
MPORTANT
N
OTICES
COPYRIGHT
No part of this manual may be reproduced, stored in a retrieval system, or transmitted, in any form or by any means -
electronic, mechanical, photocopying, recording, or otherwise - without prior written permission from Bartec.
DISCLAIMER
Bartec makes commercially reasonable efforts to provide accurate and complete data in connection with our tools and
our website, but the volume of data compiled and the variety of sources from which the data comes makes it impossible
to warrant full accuracy or completeness of any kind. AS A RESULT, BARTEC DOES NOT WARRANT, AND SPECIFICALLY
DISCLAIMS ANY WARRANTY, THAT THE SITE, TOOLS, AND/OR THE CONTENT CONTAINED THEREIN IS ACCURATE OR
COMPLETE. All specifications, illustrations and information contained within this manual are based on the most current
information available at the time of publication. Bartec USA reserves the right to make changes at any time without
obligation to notify any person or organization. Bartec USA will do its best to keep you the customer informed of any
changes that might affect the tools performance. Important items will be called out by using
“NOTE.”
Information
following this indication should always be reviewed.
FCC COMPLIANCE
FCC ID: SX8DSW9
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two conditions: (1) This device may
not cause harmful interference, and (2) This device must accept any interference received, including interference that may
cause undesired operation.
ISED COMPLIANCE
IC: 5736A-DSW9
This device contains licence-exempt transmitter(s)/receiver(s) that comply with Innovation, Science and Economic
Development Canada’s licence-exempt RSS(s). Operation is subject to the following two conditions:
1. This device may not cause interference.
2. This device must accept any interference, including interference that may cause undesired operation of the device.
L’émetteur/récepteur exempt de licence contenu dans le présent appareil est conforme aux CNR d’Innovation, Sciences et
Développement économique Canada applicables aux appareils radio exempts de licence. L’exploitation est autorisée aux
deux conditions suivantes:
1. L’appareil ne doit pas produire de brouillage.
2. L’appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage est susceptible d’en compromettre le
fonctionnement.