WALK-BEHIND TROWEL INSTRUCTION MANUAL
BARTELL MORRISON INC.
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-458-5455 FAX 905-458-5484
Created: 07/04
Revised: 08/09
- 14 -
•
While the trowel should be cleaned daily, and the electronic components are splash-resistant,
avoid spraying water or other liquids directly on the motor, starter box, or handle controls, as this
can damage the electronics. Never immerse the trowel in water. If water intrusion into the
electronics is suspected, have the trowel inspected by an authorized BMi representative before
operating.
•
Do not attempt to disable the electric safety switch on the right handle of the trowel.
•
Do not pull the trowel by the safety switch housing.
•
Always unplug the trowel for storage or transportation.
SETTING UP THE ELECTRIC POWER TROWEL
STARTING THE ELECTRIC POWER TROWEL
The Bartell Electric Power Trowel
ships without the handle attached.
When installing the handle, ensure
that the control plug at the lower end
of the handle is plugged into the
receptacle at the lower left of the
motor starter box and retained with
the clip.
The box is protected with two (2)
timed fuses. If your trowel will not
start, and the breakers at the line
and starter box are ok, then you
may need to replace the fuses.
