WALK-BEHIND TROWEL INSTRUCTION MANUAL
BARTELL MORRISON INC.
375 ANNAGEM BLVD, MISSISSAUGA, ONTARIO, CANADA, L5T 3A7, 905-458-5455 FAX 905-458-5484
Created: 07/04
Revised: 08/09
- 15 -
1. Plug the trowel into the electrical supply. If the line power is on, the green power indicator
lamp on the top of the trowel will glow.
2. Turn the master starter switch clockwise to the ON (vertical) position. If it will not stay in the
ON position, then turn it fully counterclockwise to the OFF position and try again. The internal
breaker of the starter box will not let the master switch be turned on until it has been reset by
turning it off.
3. With the master switch ON, stand at the operator position behind the handle. The motor will
not start until the safety handle is fully depressed, and it will immediately stop if the safety
handle is released. Squeeze the safety handle with your right hand until it is fully depressed,
and hold this for the duration of operation.
4. Brace your hip against the shield pad on the handle for better control. Bartell Electric Power
Trowels operate at a constant speed which is achieved immediately after startup, so there will
be some kick. With your left hand, press the green start button. The trowel will immediately
begin to turn.
NOTE:
If the trowel appears to hesitate or the motor strains for more than 3 seconds, release the
safety handle and inspect the blades for any obstructions or bonding to the concrete. Clear the
obstacle and try again.
5. To stop the trowel, simply release the safety handle or press the red stop button. Do not
release the handles until the blades have stopped rotating. If leaving the trowel for any
extended period, turn the master switch to the OFF position.
