2
PARTS LIST
WARNING: DO NOT
use while under the influence of alcohol or drugs (prescription or non-prescription) as
these may impair user’s ability to properly assemble or safely operate the appliance.
Avoid contacting moving parts. Wait until all parts have come to a complete stop and disconnect from the
power source before removing any parts of the grinder.
WARNING: NEVER
feed food into grinder by hand as serious injury may occur, always use provided meat
stomper.
DO NOT
use fingers to scrape food away from the grinding plate while the grinder is running.
Thoroughly hand-wash all grinder parts in warm soapy water prior to use.
DO NOT
soak. This product is
NOT DISHWASHER SAFE
(discoloration may occur)
Tie back loose hair and clothing. Remove neckties, rings, watches, bracelets or other jewelry before
operating the grinder.
DO NOT
run grinder without meat in the Grinder Head, severe damage to the Grinder Head and Auger
could result.
Use grinder on a level, stable surface to prevent tipping.
NEVER
move the grinder while unit is in use.
WARNING:
Knife and plates are SHARP! To avoid injury, use extreme caution when handling.
If your unit fails to operate, contact Barton for technical assistance at 909.628.0880. If meat is mashing
instead of extruding in strings from the grinding plate, chill the meat to 40˚, and check to see that the plate
and knife are properly installed. A dull knife or plate will also cause mashing of the meat.
To protect against risk of electrical shock,
DO NOT
put appliance in water or any other liquids
DO NOT
place this appliance on or near gas or electric burners or stoves.
DO NOT
place this appliance
inside or on top of a heated conventional oven, microwave oven, or other heat source or a dishwasher.
DO NOT
submerse or expose the electrical components of this product to water or any other liquids.
WARNING:
The cutting blade is sharp; always handle with care when using and while cleaning.
CAUTION: NEVER PUT YOUR FINGERS NEAR THE FOOD CHUTE WHILE GRINDER IS IN OPERATION.
To avoid a circuit overload, do not operate another electrical product on the same electrical circuit as this
product.
Disconnect the plug (
DO NOT
pull on Power Cord) from the electrical outlet.
DO NOT
put any stress on
the Power Cord where it connects to the product, as the Power Cord could fray and break.
DO NOT
use any abrasive cleaning agents or cleaning cloths or sponges when cleaning the appliance.
TECHNICAL SPECIFICATIONS
