4
CONNECTING YOUR ICE MAKER
Improper use of the grounded plug can result in the risk of electrical shock. If the power cord is
damaged please call our customer service.
1.
This unit should be properly grounded for your safety. The power cord of this appliance is equipped with
a three-prong plug which mates with standard three prong wall outlets to minimize the possibility of electric
shock.
2.
Plug your appliance into an exclusive, properly installed, grounded wall outlet. Do not under any
circumstances, cut or remove the third (ground) prong from the power cord. Any questions concerning
power and/or grounding should be directed toward a certified electrician.
3.
This appliance requires a standard 110-120volt, 60Hz electrical outlet with three-prong ground.
OPERATING YOUR ICE MAKER
1.
Open the cover, remove the ice basket and pour water into tank. Keep water level below the water
level mark.
2.
Press “Power” button on the control panel to begin the ice making cycle.
3.
Select the ice cube size by pressing the “Select” button. If the room temperature is lower than 60, it is
recommended to select small ice cube in order to avoid ice sticking together.
4.
The ice making cycle lasts approx. 6 to 13 minutes, depending on selection of ice cube size and the room
temperature. The recommended room temperature is 50 °F to 105 °F.
5.
If water pump can’t inject water, the ice maker will stop automatically, and the “Add Water” indicator will
be on. Press “Power” button, fill water up to the max. water level mark and press “Power” button again to
turn on the unit again. Allow the refrigerant liquid inside the compressor at least 3 minutes to settle before
restarting.
6.
The ice maker stops when the ice basket is full and the “Ice” indicator will be on.
Warning: Direct
sunlight or sunlight reflection may cause infrared sensor malfunction.
If the unit doesn’t stop even
ice cubes obstruct sensor, move the unit where no sunlight.
7.
Change water in the water reservoir every 24 hours to ensure a reasonable clarity levels. If unit isn’t to
be used, drain all the water and dry the tank.
CLEANING AND MAINTAINING YOUR ICE MAKER
Before using your ice maker, it is strongly recommended to clean it thoroughly.
1.
Take out the ice basket.
2.
Clean the interior with diluted detergent, warm water and a soft cloth.
3.
Then use the water to rinse the inside parts, and drain out the water by unplugging the drain cap on front
bottom side.
4.
The outside of the ice maker should be cleaned regularly with a mild detergent solution and warm water.
5.
Dry the interior and exterior with a clean soft cloth.
6.
When the machine is not to be used for a long time, drain water completely & dry the interior.
OPERATION
